This listing is for 2 loops and a phasing harness. Two 144 - 148 MHz, loop antennas. Element measures around 11 inches x 11 inches. Designed to be used for CW and SSB. For Base or Mobile use.
Tested up to 1500 watts SSB for a pair of loops. Elements are 5/16 inch diameter 6061 Aluminum solid rod. Stainless Steel U-Bolt mast clamps.
Fits up to 1-1/2 inch out side diameter pipe. Tuning is done by Gamma Match. SO-239 Silver plated / Teflon coax connectors. Assembled and tested for use at 144.200, Ready to install. If you want these tuned to a different frequency, just ask.
You can mount these antennas to a mast pipe or to the side of a Rohn 20 or 25 tower. Spacing between antennas should be 60 to 72 inches for best results. Mount antennas one above the other. DB gain will depend on installation. Typical results are 6 to 8 DB gain.
Ships UPS ground to lower 48 states USA only. You must have an actual address. Harness is made from RG-11U, 75 ohm flexible coax. Comes with Male PL-259 connectors, (T) connector & 90 degree connectors.
NOTE: This loop package and harness comes with Male PL-259 and female SO-239 connectors. I have a different listing for the package with N type connectors. Thank you for reading my listing. The item "2 x, 2 Meter, Loop, Antenna, plus phasing harness, 144 MHz" is in sale since Thursday, August 1, 2019. This item is in the category "Consumer Electronics\Radio Communication\Antennas\Ham, Amateur Radio Antennas".
The seller is "freqtester" and is located in Iowa City, Iowa. This item can be shipped to United States.