Five(5) Apollo AP700 Pagers- ($126.50 ea.) Nurse/Hosp. Replaces 924/A25/929

  

If you select a quantity other than 1, it will be for multiples of 5 pagers. Example: order a quantity of 3 to receive 15 pagers. Brand new pagers in the original gift box with user guide, chain, holster and battery. Hand-programmable for frequency, bandwidth, baud rate and up to 8 capcodes.

Printable hand-programming instructions also available from Prime Access Pagers. Be sure to select the frequency range that matches your paging system, nurse call system, or transmitter.

You will be able to easily program the pager to the exact frequency within the selected frequency range. The VHF frequency range is 150 - 160 MHZ. The UHF frequency range is 450 - 470 MHz. 4 Keys Operation, User Friendly Interface.

4 Lines, Total 84 Alphanumeric One Page Display. Large Memory Size; Total Capacity 28,672 Letters for POCSAG. 16 Memory Slots, 10 Sets Full Message. 4 Beep Alerts, 10 Melody Alerts, Vibration Sleep Mode. Large, high definition TFT alphanumeric display.

Easily hand-programmed for frequency, bandwidth, baud rate and capcodes. 1 Hold the center button while inserting the battery until "Password: 0000" is displayed, then release the button. 2 Insure that "0000" is displayed as the password and press the right button.

3 The next screen will be the frequency and one of the digits will be flashing, this is the cursor. Use the left/right buttons to move the cursor, use the center button to increase the value of the digit. You can also set the bandwidth to wide or narrow on this screen. 4 Once the frequency is set correctly press the right button to continue.

5 The next screen is the first capcode. Follow the instructions in step 3 to set the capcode, then press the right button to continue. Enter additional capcodes as needed. 6 After the 8th capcode screen you will see the baud rate screen. Press the center button to select the baud rate that is used by your system transmitter, then press the right button to continue.

7 The next screen allows you to change the password if desired. 8 The next screen allows you to adjust the display contrast. Press the right button to complete and exit the programming mode. 9 PASS appears on the screen to indicate programming completion.