220 mhz Repeater Amplifier vhf Ham radio 10-15watts in 100 watts out Continuous
220 mhz Repeater Amplifier vhf Ham Commercial 10-15 in 100 watts out Continuous! Finally a bulletproof 220 amplifier!!!! This Midcom pa-100 is a modern version of the kendecom acs pa-100. It has a 28 volt Macom transistor which is inexpensive and easy to replace if you can find a way to break it. It has about 10 db gain. With a good tune 10 watts input yields 100 watts output. The transistor is rated 125 watts and with a reasonable heatsink and fan will maintain 100 watts in repeater configuration. These are hand made and assembled. Simply bolt it down to your old broken old amplifiers heat sink feed it 28 volts with a supply that can handle 6 amps continuous and add input and output coax and you are on the air. It's just that simple. It has already been bench tested and is ready to go. This 220 amplifier has excellent low pass filtering and will work great with about 10-15 watts of drive. Just make sure you keep the output under 100 watts in repeater use. Also this amplifier is available in a 2 meter version sorry no uhf at this time. Please message with any questions.