Thicker 3.5 50KHz-200MHz/2Ghz Malachite DSP SDR Receiver Malahit SDR Shortwave Radio Receiver Nice Sound Advantages: 1. 3.5 inch capacitive screen 2. 4-layer board structure, higher performance than two-layer PCB 3. 11 Consumption: 300mA when listening to headphones; 12 The reception on built-in telescope or external antenna is to improve the HF reception on telescope antenna, and an additional board with source follower has been developed. The board will be built into standard receiver design.
13 Connect to computer via USB, which can transfer CAT, IQ and audio. 14 160 kHz span, with scalability; 15 Sensitivity: Under the condition of up to 250MHz, s/w is 0.3V = 10dB; due to lack of measurement equipment, so the above measurements were not taken; 16 Due to the characteristics of msi001 chip used, dynamic blocking range is about 85dB. 17 With backlight control; 18 SMA female antenna socket; 19 Motherboard size: 100 x 70mm (without the sizes of connectors). It can be equipped with a long wire as an antenna for easy listening.
Default frequency range: from 50 kHz to 200 MHz. Other items are not included, for demonstration purposes only.Usually it cost about 35USD-50USD. If you receive defective item, please kindly notify us within 14 days. The item "3.5inch 50KHz-2GHz Malachite DSP SDR Malahit Shortwave Radio Receiver 2 Speaker" is in sale since Monday, October 19, 2020. This item is in the category "Consumer Electronics\Radio Communication\Ham, Amateur Radio\Ham Radio Receivers". The seller is "diyradio" and is located in SZ. This item can be shipped worldwide.