4.3 50KHz-1000MHz NanoVNA-F VNA Network Antenna Analyzer UHF HF VHF / Stylus

  
4.3 50KHz-3GHz NanoVNA-F VNA Network Antenna Analyzer UHF HF VHF W/ Stylus. Support measurable frequency to 1.5 GHz, default setting 1 GHz, accurate measurement up to 1.35GHz. NanoVNA-F Mini Vector Network Analyser is a product based on the Open Source Project of NanoVNA. The RF part is consistent with the original version NanoVNA-F uses harmonic spread measurement (frequency to 1.5 GHz).

NanoVNA-F hardware functions include and are not limited to the following improvements. Use 4.3-inch IPS TFT LCD screen, with a larger view angle and can be seen clearly in strong outdoor light. Switch to large capacity 5000mAh lithium battery, standby time is longer, and expand a USB interface. Usually, it can be used as a rechargeable treasure when the instrument is not used. The IC is charged by high current 2A, and the charging time is shorter.

Change to larger and better operating wave wheel. Switch to a power switch with a greater sense of operation and a better sense of operation. Support Chinese and English menu switching.

Upgrade the user program by virtual U disk. Standard aluminium shell to protect SMA head and reduce the interference of external electromagnetic wave to instrument.

The hardware block diagram of NanoVNA-F is as follows. Dimensions: 14CM 7CM 2CM (length, width and height).

Measuring Frequency: 50kHz 1000KHz(Scalable to 1.5 GHz). Display: 4.3 inch IPS TFT (800x480). Battery: built-in 5000mAh/3.7V, theoretical battery life 18 hours. RF output: - 13 DBM (maximum - 9 dbm). Power consumption: USB 5V 200mA, maximum charging current 2A. Output capability: 5V/1A, supporting Android and Apple phones. Number of calibration points: 101. Number of scanning points: 101. Scanning time: about 1.9s/time (50kHz-1000GHz full frequency band). Measurable S parameters, voltage standing wave ratio SWR, phase diagram, group delay, Smith circle diagram... 19.0Wh (about 5000mAh after conversion) large capacity lithium battery. Designing a metal shield for the RF front end, allowing the S21 to have a dynamic range better than 60dB over the full frequency range. Power bank fuction: 5V/1A , Supporting Android and Apple Mobile. NanoVNA-F S11 parameter, SWR standing wave ratio test. UV9D antenna U-band standing wave ratio measurement, starting frequency: 300M, termination frequency: 600M, standing wave minimum frequency 441.000000MHz, SWR = 1.03. S21 insertion loss measurement, low pass, high pass, band pass filter measurement. Measuring 6.5M Ceramic Notch with NanoVNA-F. Measuring 10.7M ceramic filter using NanoVNA-F. A self-made low-pass filter was measured using the NanoVNA-F with a 3dB bandwidth of approximately 400MHz.

Performance comparison, E5071C four-port vector network vs NanoVNA-F. 1 x SMA Open Circuit Calibration Part.

1 x SMA Short-Circuit Calibration Kit. 1 x SMA 50 Load Calibration Kit. 1 x SMA-KK Double Head Female Adapter. 1 x SMA-JJ Double Head Male Adapter. 1 x SMA-JKW Elbow Female To Male adapter.

2 x 20cm SMA-JJ RG405 RF Cables. 1 x USB Type-C Data Cable.

Local pick-up is unavailable at the moment. Leaving correct address can minimize delay. We devote ourselves making EVERY CUSTOMER in 100% Satisfactory and resolve any problem. We highly value and appreciate your business.

(Excluding contrived damagement or misusage). All messages will be answered within 24 office hours.

We are committed to resolve all issues in a friendly and satisfactory manner. If you do not get a response from us, then please check your junk or spam mailbox. The item "4.3 50KHz-1000MHz NanoVNA-F VNA Network Antenna Analyzer UHF HF VHF / Stylus" is in sale since Wednesday, July 14, 2021. This item is in the category "Business & Industrial\Test, Measurement & Inspection\Analyzers & Data Acquisition\Network Analyzers". The seller is "homemj231" and is located in Walnut, California. This item can be shipped worldwide.

• Battery: 5000mAh Li-ion Battery
• Brand: Unbranded
• Color: Black
• Display: 4.3inch, Resolution 800*480
• Frequency accuracy: <0.5ppm
• Frequency Range: 50KHz -1000MHz
• Model: NanoVNA-F
• MPN: Does Not Apply
• Network Analyzer Type: Vector
• Number of calibration points: 101 points
• Number of mark points: 4 (the mark point bar can be moved up and down on the screen)
• Number of scanning points: 101 points
• Port SWR: < 1.1
• RF output: - 13 DBM (maximum - 9 dbm)
• Scan tim: about 1.9s/1 time
• Setting save: 5 groups
• USB interface: USB Type-C communication mode: CDC (serial)