Measures 11 inches x 11 inches. Designed for CW and SSB, Horizontal polarity.
For Base or Mobile use. Tested up to 1000 watts SSB for a single loop. Element is 5/16 inch diameter 6061 Aluminum solid rod. Stainless Steel U-Bolt mast clamp.
Fits up to 1-1/2 inch outside diameter pipe. Tuning is done by Gamma Match. SO-239 Silver plated / Teflon coax connector.
Assembled and tested for use at 144.200, Ready to install. You can mount this antenna to a mast pipe or to the side of a Rohn 20 or 25 tower. DB gain will depend on installation. Typical results are 2 to 4 DB. Note: This loop comes with a SO-239 Female connector. I use only American made Aluminum & Stainless Steel. 420-450 MHz, one full wave length, square loop antenna. Element measures 7 inches x 8-1/2 inches. Much larger than the half wave length others sell.Designed for CW and SSB use. SWR less than 1.2 to 1 , 430 to 434 MHz.
Less than 1.5 to 1 , 420 to 437.500 MHz. Tested up to 800 watts SSB for a single loop. SO-239 Silver plated / Teflon connector.
Assembled and tested for use at 432.100 to 432.200 MHz. You can mount this antenna to a mast pipe on a tower. To the side of a Rohn 20 or 25 tower. Or mount it on your rover for contesting. Ships UPS ground to lower 48 states USA only. You must have an actual address. Note: I also have the female type (N) connector available if you do not want the SO-239. Please contact me before purchasing if you want the N type connector. If you have one of those radio's that has a shared coax connector for both 144 & 432 MHz.I sell a harness rated at 1000 watts that allows you to connect both of these antennas to one coax cable. Thank you for reading my listing. The item "Loop Package, 1 X 144 MHz, LOOP, 1 X 432 MHz, LOOP, ANTENNA, HAM RADIO" is in sale since Tuesday, October 16, 2018. This item is in the category "Consumer Electronics\Radio Communication\Antennas\Ham, Amateur Radio Antennas".
The seller is "freqtester" and is located in Iowa City, Iowa. This item can be shipped to United States.